Configuring PIM show ip pim rp
17-8 PIM Configuration
Parameters
Defaults
Ifnotspecified,informationaboutallPIMinterfaceswillbedisplayed.
Mode
Routercommand,PrivilegedEXEC:Matrix>Router#
Example
ThisexampleshowshowtodisplayPIMneighborinformation:
Matrix>Router#show ip pim neighbor
Neighbor Address Vlan DR Priority Uptime Expires Mode ------
------------------------------------------------------------------------
10.0.0.2 10 1 00:03:34 00:01:40 PIMSM_MODE (DR)
Table 17‐3providesanexplanationofthecommandoutput.
show ip pim rp
Usethiscommandtodisplaytheactiverendezvouspoints(RPs)thatarecachedwithassociated
multicastroutingentries.
Syntax
show ip pim rp [group | mapping | multicast-group-address]
interface (Optional)DisplaysinformationaboutaspecificPIMinterface.This
interfacemustbeenabledwithPIMasdescribedin“ippimsparse
mode”onpage 17 ‐2.
Table 17-3 show ip pim neighbor Output Details
Output... What it displays...
Neighbor Address IP address of the PIM neighbor.
Vlan VLAN ID of the PIM interface.
DR Priority DR priority of the neighbor.
Uptime Interval in hours, minutes, and seconds the entry has been in the PIM
neighbor table.
Expires Interval in hours, minutes, and seconds until the entry will be removed
from the IP multicast routing table.
Mode Mode in which the interface is operating.
(DR) Indicates that this neighbor is a designated router on the LAN.
To Next Page
Loading...
Need help?
General