Enterasys Matrix DFE-Gold Series

Cisco Discovery Protocol show ciscodp
3-8 Discovery Protocols Configuration
Cisco Discovery Protocol
Purpose
Toenableandconfigurethe CiscoDiscoveryProtocol,usedtodiscovernetworktopology.When
enabled,theCiscoDiscoveryProtocolallowsCiscodevicestosendperiodicPDUsabout
themselvestoneighboringdevices.TheCiscoDiscoveryProtocolisalsousedtomanagetheCisco
moduleoftheConvergenceEndPoints(CEP)IPphone
detectionfunctiondescribedin
“ConfiguringConvergenceEndPoints(CEP)PhoneDetection”onpage 25‐39.
Commands
show ciscodp
UsethiscommandtodisplayglobalCiscoDiscoveryProtocolinformation.
Syntax
show ciscodp
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayCiscoDiscoveryProtocolinformation.Inthiscase,defaults
havenotbeenchanged:
Matrix>show ciscodp
CiscoDP : Auto
Timer : 60
Holdtime (TTL) : 180
For information about... Refer to page...
show ciscodp 3-8
show ciscodp port info 3-9
set ciscodp status 3-10
set ciscodp timer 3-11
set ciscodp holdtime 3-11
set ciscodp port 3-12
clear ciscodp 3-13