Enterasys Matrix DFE-Gold Series

set inlinepower powertrap Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-65
set inlinepower powertrap
UsethiscommandtodisableorenablethesendingofanSNMPtrapmessagewheneverthestatus
ofthechassisPoEpowersuppliesorthePoEsystemredundancychanges.
Syntax
set inlinepower powertrap {disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoenableachassispowersuppliestrap:
Matrix(rw)->set inlinepower powertrap enable
clear inlinepower powertrap
Usethiscommandtoresetchassispowertrapmessagingbacktothedefaultstateofdisabled.
Syntax
clear inlinepower powertrap
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetchassispowertrapmessagingtodisabled:
Matrix(rw)->clear inlinepower powertrap
disable|ena ble Disablesorenablesachassispowersuppliestrapmessaging.