Enterasys Matrix DFE-Gold Series

show authentication login Setting the Authentication Login Method
Enterasys Matrix DFE-Gold Series Configuration Guide 25-51
show authentication login
Usethiscommandtodisplaythecurrentauthenticationloginmethod.
Syntax
show authentication login
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythecurrentauthenticationloginmethod:
Matrix(rw)->show authentication login
Current authentication login is any
set authentication login
Usethiscommandtosettheauthenticationloginmethod.
Syntax
set authentication login {any | local | radius | tacacs}
Parameters
For information about... Refer to page...
show authentication login 25-51
set authentication login 25-51
clear authentication login 25-52
any Specifiesthattheauthenticationprotocolwillbeselectedusingthe
followingprecedenceorder:
•TACACS+
•RADIUS
•Local
local Specifiesthatthelocalnetworkpasswordsettingswillbeusedfor
authenticationlogin.
radius SpecifiesthatRADIUSwillbeusedforauthenticationlogin.
tacacs SpecifiesthatTACACS+willbeusedforauthenticationlogin.