Enterasys Matrix DFE-Gold Series - Show Igmp Static; Set Igmp Add-Static

show igmp static Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-11
Example
ThisexampleshowshowtodisplayIGMPgroupinformationforVLAN105.Inthisexample,the
deviceknowstoforwardallmulticasttrafficforIPgroupaddress224.0.0.2(VLAN105)toFast
Ethernetport2inmodule2,and1‐GigabitEthernetport14inmodule3:
Matrix(rw)->show igmp groups 105
-----------------------------------------------------------
Vlan Id = 105 Multicast Group Address = 224.0.0.2 Type = IGMP
IGMP Port List = fe.2.2 ge.3.14
show igmp static
UsethiscommandtodisplaystaticIGMPportsforoneormoreVLANsorIGMPgroups.
Syntax
show igmp static vlan-list [group group]
Parameters
Defaults
Ifnotspecified,staticIGMPinformationwillbedisplayedforallgroups.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaystaticIGMPinformationforVLAN105.Thedisplayissimilar
totheshowigmpgroupsdisplay:
Matrix(rw)->show igmp static 105
-----------------------------------------------------------
Vlan Id = 105 Multicast Group Address = 224.0.0.2 Type = IGMP
IGMP Port List = fe.2.2 ge.3.14
set igmp add-static
UsethiscommandtocreateanewstaticIGMPentry,ortoaddoneormorenewportstoan
existingentry.
Syntax
set igmp add-static group vlan-list [modify] [include-ports] [exclude-ports]
Parameters
vlan‐list SpecifiestheVLAN(s)forwhichtodisplaystaticIGMPinformation.
groupgroup (Optional)DisplaysinformationforaspecificIGMPgroup(IPaddress).
group SpecifiesagroupIPaddressfortheentry.
vlan‐list SpecifiestheVLAN(s)onwhichtoconfiguretheentry.