Enterasys Matrix DFE-Gold Series

network Configuring OSPF
Enterasys Matrix DFE-Gold Series Configuration Guide 21-23
Mode
Routercommand,Globalconfiguration:Matrix>Router(config)#
Usage
YoumustexecutetherouterospfcommandtoenabletheprotocolbeforecompletingmanyOSPF‐
specificconfigurationtasks.Fordetailsonenablingconfigurationmodes,refertoTable 2‐8in
“EnablingRouterConfigurationModes”onpage 2‐103.
OnlyoneOSPFprocess(process‐id)isallowedperEnterasysMatrixSeriesrouting
moduleor
standalonedevice.
The“no”formofthiscommanddisablesOSPFconfigurationmode.
Example
ThisexampleshowshowtoenableroutingforOSPFprocess1:
Matrix>Router#conf terminal
Matrix>Router(config)#router ospf 1
Matrix>Router(config-router)#
network
UsethiscommandtoconfigureareaIDsforOSPFinterfaces.
Syntax
network ip-address wildcard-mask area area-id
no network ip-address wildcard-mask area area-id
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
Usage
The“no”formofthiscommandremovesOSPFroutingforinterfacesidentifiedbytheIPaddress
andmaskparameters.
ip‐address SpecifiestheIPaddressofaninterfaceoragroupofinterfaceswithin
thenetworkaddressrange.
wildcard‐mask SpecifiestheIP‐address‐typemaskthatincludes“donʹtcare”bits.
area
area‐id Specifiesthearea‐idtobeassociatedwiththeOSPFaddressrange.Valid
valuesaredecimalvaluesorIPaddresses.Asubnetaddresscanbe
specifiedasthearea‐idtoassociateareaswithIPsubnets.