Enterasys Matrix DFE-Gold Series

Configuring Load Sharing Network Address Translation (LSNAT) clear router limits (LSNAT)
19-34 LSNAT Configuration
Defaults
•Ifnotspecified,maximumbindingswillbesettothedefaultvalueof5000.
•Ifnotspecified,cachesizewillbesettothedefaultvalueof1000.
•Ifnotspecified,maximumconfigswillbesettothedefaultvalueof50.Thatis,upto50server
farms,50virtualservers,
and50directaccessentriescanbeconfigured,andupto500real
serversand500clientaccessentriescanbeconfigured.
Mode
Switchcommand,Read‐Write.
Usage
Thechassisorsystemmustberebootedforanynewchangetotakeeffect.
ThiscommandmustbeexecutedfromtheswitchCLI.
Example
ThisexampleshowshowtosettheLSNATconfigurationlimitto25.Thismeansthatupto25
serverfarms,25virtualservers,and25directaccessentriescanbeconfigured,andupto250real
serversand250clientaccessentriescanbeconfigured.
Matrix(rw)->set router limits lsnat-configs 25
clear router limits (LSNAT)
Usethiscommandtoresetchassis‐basedLSNATlimitstodefaultvalues.
Syntax
clear router limits [lsnat-bindings] | [lsnat-cache] | [lsnat-configs]
Parameters
Defaults
Ifnooptionsarespecified,allLSNATlimitswillbereset.
Note: Router limits can also be set in the following contexts:
To set NAT router limits see “set router limits (NAT)” on page 18-14.
To set TWCB router limits see “set router limits (TWCB)” on page 23-15.
lsnat‐bindings (Optional)ResetstheLSNATmaximumbindingslimittothedefault
valueof5000.
lsnat‐cache (Optional)ResetstheLSNATcachesizelimittothedefaultvalueof
2000.
lsnat‐configs (Optional)ResetstheLSNATconfigurationlimittothedefaultvalueof
50.