Enterasys Matrix DFE-Gold Series

clear port ratelimit Configuring Port Traffic Rate Limiting
Enterasys Matrix DFE-Gold Series Configuration Guide 22-11
Defaults
•Ifnotspecified,thresholdwillbeappliedtoinboundtrafficontheport/priority.
•Ifindexisnotspecified,settingswillbeappliedtoindex1,andwilloverwriteindex1forany
subsequentratelimitsconfigured.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowto:
• globallyenableratelimiting
• configureratelimitingforinboundtrafficonportfe.2.1,index1,priority5,toathresholdof
125 KBps:
Matrix(rw)->set port ratelimit enable
Matrix(rw)->set port ratelimit fe.2.1 5 125 enable inbound
clear port ratelimit
Usethiscommandtoclearratelimitingparametersforoneormoreports.
Syntax
clear port ratelimit port-string [index]
Parameters
Defaults
Ifnotspecified,allindexentrieswillbereset.
Mode
Switchcommand,Read‐Write.
priority Specifiesthe802.1D(802.1p)portprioritylevelassociatedwiththeport‐
string.Optionsare:
• 0‐7,with0specifyingthelowestpriority,and
• alltosettheratelimitingthresholdandotherparametersonall
portprioritylevelsassociatedwiththeport‐string.
threshold Specifies a
portratelimitingthresholdinkilobytespersecond.Rangeis
64uptothemaximumbytespersecondrateforagiveninterface.
inbound (Optional)Appliesthisratepolicingruletoinboundoroutbound
traffic.
index (Optional)Assignsaresourceindexforthisport.
port‐string Specifiestheport(s)onwhichtoclearratelimiting.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
index (Optional)Specifiestheassociatedresourceindextobereset.