Enterasys Matrix DFE-Gold Series

clear policy profile Configuring Policy Profiles
Enterasys Matrix DFE-Gold Series Configuration Guide 8-5
clear policy profile
Usethiscommandtodeleteapolicyprofileentry.
Syntax
clear policy profile profile-index
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtodeletepolicyprofile8:
Matrix(rw)->clear policy profile 8
show policy invalid
Displaysinformationaboutthe actionthedevicewillapplyonaninvalidorunknownpolicy.
Syntax
show policy invalid {action | count | all}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplayinvalidpolicyactionandcountinformation:
Matrix(rw)->show policy invalid all
Current action on invalid/unknown profile is: Forward packets
Number of invalid/unknown profiles detected: 4
profile‐index Specifies theindexnumberofthepolicyprofileentrytobedeleted.
Validvaluesare1to1023.
action|count|all Showstheactionthedeviceshouldtakeifaskedtoapplyaninvalidor
unknownpolicy,orthenumberoftimesthedevicehasdetectedan
invalid/unknownpolicy,orbothactionandcountinformation.