Configuring RMON show rmon history
11-18 Network Monitoring Configuration
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodeleteRMONstatisticsentry2:
Matrix(rw)->clear rmon stats 2
show rmon history
UsethiscommandtodisplayRMONhistorypropertiesandstatistics.TheRMONhistorygroup
recordsperiodicstatisticalsamplesfromanetwork.
Syntax
show rmon history [port-string] [wide] [interval]
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallRMONhistoryentrieswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplayRMONhistoryentriesforFastEthernetport14inmodule3.
Acontrolentrydisplaysfirst,followedbyactualentriescorrespondingtothecontrolentry.Inthis
case,thedefaultsettingsforentryowner,samplinginterval,andmaximumnumberofentries.
(buckets)havenotbeen
changedfromtheirdefaultvalues(asdescribedin“setrmonhistory”on
page 11‐19).Foradescriptionofthetypesofstatisticsshown,refertoTable 11‐3:
Matrix(rw)->show rmon history fe.3.14
Port: fe.3.14
---------------------------------------
Index 1001
Status = 1 valid
Owner = monitor
Data Source = 1.3.6.1.2.1.2.2.1.1.11001
Interval = 30
Buckets Requested = 50
Buckets Granted = 50
port‐string (Optional)DisplaysRMONhistoryentriesforspecificport(s).
wide (Optional)Displaymostimportantstats,onelineperentry.
interval (Optional)Summarizehistoryoverafixedinterval.