Enterasys Matrix DFE-Gold Series

show port vlan Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Enterasys Matrix DFE-Gold Series Configuration Guide 7-9
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
Purpose
ToassigndefaultVLANIDstountaggedframesononeormoreports,toconfigureMIB‐II
interfacemappingtoaVLAN,toconfigureVLANingressfiltering,andtosettheframediscard
mode.
Commands
show port vlan
UsethiscommandtodisplayportVLANidentifier(PVID)information.
Syntax
show port vlan [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,portVLANinformationforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
For information about... Refer to page...
show port vlan 7-9
set port vlan 7-10
clear port vlan 7-11
show vlan interface 7-11
set vlan interface 7-12
clear vlan interface 7-13
show port ingress filter 7-13
set port ingress filter 7-14
show port discard 7-15
set port discard 7-15
clear port discard 7-16
port‐string (Optional)DisplaysPVIDinformationforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.