Enterasys Matrix DFE-Gold Series

ip rip offset Configuring RIP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-5
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix>Router(config‐router)#
Usage
Ifseveralroutes(comingfromdifferentprotocols)arepresentedtotheEnterasysMatrixSeries
RouteTableManager(RTM),theprotocolwiththelowestadministrativedistancewillbechosen
forrouteinstallation.Bydefault,RIPadministrativedistanceissetto120.Thedistancecommand
canbeusedtochangethisvalue,resetting
RIP’sroutepreferenceinrelationtootherroutesas
showninthetablebelow.
The“no”formofthiscommandresetsRIPadministrativedistancetothedefaultvalueof 12 0.
Example
ThisexampleshowshowtochangethedefaultadministrativedistanceforRIPto1001:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#distance 100
ip rip offset
UsethiscommandtoaddorremoveanoffsettothemetricofanincomingoroutgoingRIProute.
Syntax
ip rip offset {in | out} value
no ip rip offset {in | out}
Parameters
weight Specifies anadministrativedistanceforRIProutes.Validvaluesare1‐
255.
Route Source Default Distance
Connected 0
Static 1
OSPF 110
RIP 120
in Appliestheoffsettoincomingmetrics.
out Appliestheoffsettooutgoingmetrics.
value SpecifiesapositiveoffsettobeappliedtorouteslearnedviaRIP. Valid
valuesarefrom0to16.Ifthe valueis0,noactionistaken.