Enterasys Matrix DFE-Gold Series

Creating and Naming Static VLANs set vlan
7-6 802.1Q VLAN Configuration
Creating and Naming Static VLANs
Purpose
TocreateanewstaticVLAN,ortoenableordisableexistingVLAN(s).
Commands
set vlan
UsethiscommandtocreateanewstaticIEEE802.1QVLAN,ortoenableordisableanexisting
VLAN.
Syntax
setvlan{create|enable|disable}vlan‐list
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
EachVLANIDmustbeunique.IfaduplicateVLANIDisentered,thedeviceassumesthatthe
AdministratorintendstomodifytheexistingVLAN.
EntertheVLANIDusingauniquenumberbetween2and4094.TheVLANIDsof0,1,and4094
andhighermaynotbeused
foruser‐definedVLANs.
OnceaVLANiscreated,youcanassignitanameusingthesetvlannamecommanddescribedin
“setvlanname”onpage 7‐7.
For information about... Refer to page...
set vlan 7-6
set vlan name 7-7
clear vlan 7-7
clear vlan name 7-8
create|enable|
disable
Creates,enablesordisablesVLAN(s).
vlan‐list SpecifiesoneormoreVLANIDstobecreated,enabledordisabled.