Enterasys Matrix DFE-Gold Series

Setting Console Port Properties
Enterasys Matrix DFE-Gold Series Configuration Guide 4-3
fe.1.1-10
Thisexampleshowstheport‐stringsyntaxforspecifyingthe1‐GigabitEthernetport14inthe
moduleinchassisslot 3.
ge.3.14
Thisexampleshowstheport‐stringsyntaxforspecifyingFastEthernetports1and3andGigabit
Ethernetport11inthemoduleinchassisslot 1:
fe.1.1,fe.1.3;ge.1.11
Thisexampleshowstheport‐stringsyntaxforspecifyingFastEthernetports1,3,7,8,9and10in
themoduleinchassisslot 1:
fe.1.1,fe.1.3,fe.1.7-10
Thisexampleshowstheport‐stringsyntaxforspecifyingthe10‐GigabitEthernetport2ofthe
moduleinchassisslot 3.
tg.3.1
Thisexampleshowstheport‐stringsyntaxforspecifyingall1‐GigabitEthernetportsinthemodule
inchassisslot 3.
ge.3.*
Thisexampleshowstheport‐stringsyntaxforspecifyingall10‐GbpsEthernetportsinthechassis.
tg.*.*
Thisexampleshowstheport‐stringsyntaxforspecifyingallports(ofanyinterfacetype)inall
modulesinthechassis
*.*.*
Setting Console Port Properties
Purpose
Toreviewandsetparametersforoneormoreofthedevice’sconsoleports,includingbaudrate,
autobauddetection,stopbitsandparity.
Commands
Thecommandsusedtoreviewandconfigureconsoleportsettingsarelistedbelowanddescribed
intheassociatedsectionasshown.
For information about... Refer to page...
show console 4-4
clear console 4-4
show console baud 4-5
set console baud 4-5
clear console baud 4-6
show console flowcontrol 4-6
set console flowcontrol 4-7
clear console flowcontrol 4-7