Enterasys Matrix DFE-Gold Series

Setting Speed and Duplex Mode show port speed
4-24 Port Configuration
Setting Speed and Duplex Mode
Purpose
ToreviewandsettheoperationalspeedinMbpsandthedefaultduplexmode:Half,forhalf
duplex,orFull,forfullduplexforoneormoreports.
Commands
show port speed
Usethiscommandtodisplaythedefaultspeedsettingononeormoreports.
Syntax
show port speed [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,defaultspeedsettingsforallportswilldisplay.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythedefaultspeedsettingfor1‐GigabitEthernetport14in
module3:
Matrix(rw)->show port speed ge.3.14
default speed is 1000 on port ge.3.14.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 4-24
set port speed 4-25
show port duplex 4-25
set port duplex 4-26
port‐string (Optional)Displaysdefaultspeedsetting(s)for specificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.