Enterasys Matrix DFE-Gold Series

set igmp config Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-9
set igmp config
UsethiscommandtoconfigureIGMPsettingsononeormoreVLANs.
Syntax
set igmp config vlan-list {[query-interval query-interval] [igmp-version igmp-
version] [max-resp-time max-resp-time] [robustness robustness] [last-mem-int
last-mem-int]}
Parameters
Defaults
Atleastoneoptionalparametermustbespecified.
Mode
Switchcommand,Read‐Write.
Vlan IGMP Version Whether or not IGMP version is 1 or 2.
VlanQuerier IP address of the IGMP querier.
VlanQueryMaxResponse
Time
Maximum query response time (in tenths of a second).
VlanRobustness Robustness value.
VlanLastMemberQueryIntvl Last member query interval. This is the maximum response time
inserted into group-specific queries which are sent in response to
Leave Group messages. It is also the amount of time between group-
specific query messages.
VlanQuerierUpTime Time (in seconds) the IGMP querier has been active.
Table 9-1 show igmp config Output Details (continued)
Output... What it displays...
vlan‐list SpecifiestheVLAN(s)onwhichtoconfigureIGMP.
query‐intervalquery‐
interval
(Optional)Specifiesthefrequencyofhost‐queryframetransmissions.
Validvaluesarefrom1to65535seconds.Thisvalueworkstogether
withmax‐resp‐timetoremoveportsfromanIGMPgroup.
igmp‐versionigmp‐
version
(Optional)Specifiesthe
IGMPversion.Validvaluesare:
• 1‐IGMPV1
• 2‐IGMPV2
max‐resp‐timemax‐
resp‐time
(Optional)Specifiesthemaximumqueryresponsetime.Validvalues
are1to25seconds.Thisvalueworkstogetherwithquery‐intervalto
removeportsfromanIGMPgroup.
robustnessrobustness (Optional)Specifiestherobustnessvalue.
Thiscanbeincreasedtotune
forexpectedpacketlossonasubnet.Validvaluesare2to255.
last‐mem‐intlast‐
mem‐int
(Optional)SpecifiestheLastMemberQueryInterval.Thisisthe
maximumresponsetimeinsertedintogroup‐specificquerieswhichare
sentinresponsetoLeaveGroup
messages.Itisalsotheamountoftime
betweengroup‐specificquerymessages.Validvaluesare1to255.