Startup and General Configuration Summary
2-10 Startup and General Configuration
remote Show users with remote SNMP engine ID
volatile Show temporary entries
nonvolatile Show permanent entries
read-only Show r/o entries
<cr>
Matrix(rw)->show snmp user
Enteringaquestionmark(?)withoutaspaceafterapartialkeywordwilldisplayalistof
commandsthatbeginwiththepartialkeyword.Figure 2‐3showshowtousethisfunctionforall
commandsbeginningwithco:
Figure 2-3 Performing a Partial Keyword Lookup
Matrix(rw)->co?
configure Execute a configuration file
copy Upload or download an image or configuration file
Matrix(rw)->co
Displaying Scrolling Screens
IftheCLIscreenlengthhasbeensetusingthesetlengthcommandasdescribedin“setlength”on
page 2‐52,CLIoutputrequiringmorethanonescreenwilldisplay‐‐More‐‐toindicatecontinuing
screens.Todisplayadditionalscreenoutput:
•PressanykeyotherthanENTERtoadvancetheoutput
onescreenatatime.
•PressENTERtoadvancetheoutputonelineatatime.
TheexampleinFigure 2‐4showshowtheshowmaccommandindicatesthatoutputcontinueson
morethanonescreen.
Figure 2-4 Scrolling Screen Output
Matrix(rw)->show mac
MAC Address FID Port Type
----------------------------------------------------------
00-00-1d-67-68-69 1 host.0.1 learned
00-00-02-00-00-00 1 fe.1.2 learned
00-00-02-00-00-01 1 fe.1.3 learned
00-00-02-00-00-02 1 fe.1.4 learned
00-00-02-00-00-03 1 fe.1.5 learned
00-00-02-00-00-04 1 fe.1.6 learned
00-00-02-00-00-05 1 fe.1.7 learned
00-00-02-00-00-06 1 fe.1.8 learned
00-00-02-00-00-07 1 fe.1.9 learned
00-00-02-00-00-08 1 fe.1.10 learned
--More--
Note: At the end of the lookup display, the system will repeat the command you entered without the
?.