Enterasys Matrix DFE-Gold Series

Configuring LACP show lacp
4-58 Port Configuration
show lacp
UsethiscommandtodisplaytheglobalLACPenablestate,ortodisplayinformationaboutoneor
moreaggregatorports.
Syntax
show lacp [state | port-string]
Parameters
Defaults
•Ifstateisnotspecified,aggregatorinformationwillbedisplayedforspecifiedports.
•Ifport‐stringisnotspecified,linkaggregationinformationforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Usage
EachMatrixSeriesmoduleprovides4virtuallinkaggregatorports,whicharedesignatedinthe
CLIaslag.0.1throughlag.0.4.Onceunderlyingphysicalports(i.e.;fe.x.x,ge.x.x)areassociated
withanaggregatorport,theresultingaggregationwillberepresentedasoneLinkAggregation
Group(LAG)withalag.x.xport
designation.
Example
Thisexampleshowshowtodisplayinformationforaggregatorport4:
Matrix(rw)->show lacp lag.0.484
Aggregator: lag.0.484
clear singleportlag 4-64
show port lacp 4-65
set port lacp 4-66
clear port lacp 4-68
show lacp flowRegeneration 4-69
set lacp flowRegeneration 4-69
clear lacp flowRegeneration 4-70
show lacp outportAlgorithm 4-70
set lacp outportAlgorithm 4-71
clear lacp outportAlgorithm 4-71
For information about... Refer to page...
state (Optional)DisplaystheglobalLACPenablestate.
port‐string (Optional)DisplaysLACPinformation forspecificLAGport(s).Valid
portdesignationsarelag.0.1‐4.