Enterasys Matrix DFE-Gold Series

show igmp query Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-5
Configuring IGMP
Purpose
TodisplayandsetIGMPconfigurationparameters,includingqueryintervalandresponsetime
settings,andtocreateandconfigurestaticIGMPentries.
Commands
show igmp query
UsethiscommandtodisplaytheIGMPquerystatusofoneormoreVLANs.
Syntax
show igmp query vlan-list
Parameters
For information about... Refer to page...
show igmp query 9-5
set igmp query-enable 9-6
set igmp query-disable 9-6
show igmp grp-full-action 9-7
set igmp grp-full-action 9-7
show igmp config 9-8
set igmp config 9-9
set igmp delete 9-10
show igmp groups 9-10
show igmp static 9-11
set igmp add-static 9-11
set igmp remove-static 9-12
show igmp protocols 9-13
set igmp protocols 9-13
clear igmp protocols 9-14
show igmp vlan 9-14
show igmp reporters 9-15
show igmp flows 9-16
show igmp counters 9-16
show igmp number-groups 9-17
vlan‐list SpecifiestheVLAN(s)forwhichtodisplayIGMPquerystate.