Enterasys Matrix DFE-Gold Series

ip irdp Configuring IRDP
Enterasys Matrix DFE-Gold Series Configuration Guide 21-55
Configuring IRDP
Purpose
ToenableandconfiguretheICMPRouterDiscoveryProtocol(IRDP)onaninterface.Thisprotocol
enablesahosttodeterminetheaddressofarouteritcanuseasadefaultgateway.
Commands
ip irdp
UsethiscommandtoenableordisableIRDPonaninterface.
Syntax
ip irdp
no ip irdp
Parameters
None.
Defaults
None.
Mode
Routercommand,Interfaceconfiguration:Matrix>Router(config‐if(Vlan1))#
Usage
The“no”formofthiscommanddisablesIRDPonaninterface.
Example
ThisexampleshowshowtoenableIRDPonVLAN1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip irdp
For information about... Refer to page...
ip irdp 21-55
ip irdp maxadvertinterval 21-56
ip irdp minadvertinterval 21-56
ip irdp holdtime 21-57
ip irdp preference 21-58
ip irdp address 21-58
no ip irdp multicast 21-59
show ip irdp 21-59