Enterasys Matrix DFE-Gold Series

Configuring SNMP Users, Groups and Communities show snmp user
5-10 SNMP Configuration
Configuring SNMP Users, Groups and Communities
Purpose
ToreviewandconfigureSNMPusers,groupsandv1andv2communities.Thesearedefinedas
follows:
•User—ApersonregisteredinSNMPv3toaccessSNMPmanagement.
•Group—Acollectionofuserswhosharethesa meSNMPaccessprivileges.
• Community—AnameusedtoauthenticateSNMP v1andv2users.
Commands
show snmp user
UsethiscommandtodisplayinformationaboutSNMPusers.Thesearepeopleregisteredto
accessSNMPmanagement.
Syntax
show snmp user [list] | [user] | [remote remote ] [volatile | nonvolatile | read-
only]
Parameters
Defaults
•Iflistisnotspecified,detailedSNMPinformationwillbedisplayed.
For information about... Refer to page...
show snmp user 5-10
set snmp user 5-12
clear snmp user 5-12
show snmp group 5-13
set snmp group 5-14
clear snmp group 5-15
show snmp community 5-15
set snmp community 5-16
clear snmp community 5-17
list (Optional)DisplaysalistofregisteredSNMPusernames.
user (Optional)Displaysinformationaboutaspecificuser.
remoteremote (Optional)DisplaysinformationaboutusersonaspecificremoteSNMP
engine.
volatile|nonvolatile
|read‐only
(Optional)Displaysuserinformationforaspecifiedstoragetype.