Enterasys Matrix DFE-Gold Series

show spantree spanguardlock Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-39
show spantree spanguardlock
Usethiscommandtodisplaythespanguardlockstatusofoneormoreports.
Syntax
show spantree spanguardlock port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
Thisexampleshowshowtodisplaythespanguardlockstatusforge.2.1:
Matrix(rw)->show spantree spanguardlock ge.2.1
spanguard status for port ge.2.1 is UNLOCKED.
clear / set spantree spanguardlock
UseeitherofthesecommandstounlockoneormoreportslockedbytheSpanningTreespan
guardfunction.
Syntax
clear spantree spanguardlock port-string
setspantreespanguardlockport‐string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
Whenspanguardisenabled,itlocksportsthatreceiveBPDUswhenthoseportshavebeen
definedasedge(user)ports(asdescribedin“setspantreeadminedge”onpage 6‐60).
port‐string Specifiestheport(s)forwhichtoshowspanguardlockstatus.Fora
detaileddescriptionofpossibleport‐string
values,referto“ PortString
SyntaxUsedintheCLI”onpage 4‐2.
port‐string Specifiesport(s)tounlock.Foradetaileddescriptionofpossibleport‐
stringvalues,referto“PortStringSyntaxUsedintheCLI”onpage 4‐2.