Enterasys Matrix DFE-Gold Series

clear spantree adminedge Configuring Spanning Tree Port Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-61
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtosetfe.1.11asanedgeport:
Matrix(rw)->set spantree adminedge fe.1.11 true
clear spantree adminedge
UsethiscommandtoresetaSpanningTreeporttonon‐edgestatus.
Syntax
clear spantree adminedge port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetfe.1.11asanon‐edgeport:
Matrix(rw)->clear spantree adminedge fe.1.11
show spantree operedge
UsethiscommandtodisplaytheSpanningTreeedgeportoperatingstatusforaport.
Syntax
show spantree operedge [port port-string]
Parameters
Defaults
Ifport‐stringisnotspecifiededgeportoperatingstatuswillbedisplayedforallSpanningTree
ports.
port‐string Specifiesport(s)onwhichtoresetedgeportstatus.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
portport‐string (Optional)Displaysedgeportoperatingstatusforspecificport(s).Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.