Enterasys Matrix DFE-Gold Series

show ip address Setting Basic Device Properties
Enterasys Matrix DFE-Gold Series Configuration Guide 2-31
show ip address
UsethiscommandtodisplaythesystemIPaddressandsubnetmask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaythesystemIPaddressandsubnetmask:
Matrix(rw)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20 255.255.0.0
set ip address
UsethiscommandtosetthesystemIPaddress,subnetmaskanddefaultgateway.
Syntax
set ip address ip-address [mask ip-mask] [gateway ip-gateway]
set system contact 2-51
set width 2-51
set length 2-52
show logout 2-52
set logout 2-53
show physical alias 2-53
set physical alias 2-54
clear physical alias 2-55
show physical assetid 2-55
set physical assetid 2-56
clear physical assetid 2-56
For information about... Refer to page...