Enterasys Matrix DFE-Gold Series - Graceful-Restart Strict-Lsa-Checking-Disable

graceful-restart strict-lsa-checking-disable Configuring OSPF
Enterasys Matrix DFE-Gold Series Configuration Guide 21-41
Parameters
Defaults
None.
Mode
Routercommand,Routerconfiguration:Matrix‐>Router(config‐router)#
Usage
Therestartintevalsetsthemaximumamountoftimethatthisrouterwillremainingraceful
restartonceanOSPFrestartisinitiated.
The“no”formofthiscommandresetsthegraceful‐restartrestart‐intervaltoitsdefaultvalue.
Example
Thisexamplesetsthegracefulrest artrestart‐intervalto300seconds:
Matrix->Router(config)#router ospf 1
Matrix->Router(config-router)#graceful-restart enable
Matrix->Router(config-router)#graceful-restart restart-interval 300
graceful-restart strict-lsa-checking-disable
UsethiscommandtodisablestrictLSAcheckingduringgracefulrestart.
Syntax
graceful-restart strict-lsa-checking-disable
no graceful-restart strict-lsa-checking-disable
Parameters
None.
Defaults
StrictLSAcheckingenabled.
Mode
Routercommand,Routerconfiguration:Matrix‐>Router(config‐router)#
Usage
StrictLSAcheckingassuresthatgracefulrestartwillterminateifthereisachangedLSAonthe
restartingrouter’sretransmissionlistwhengracefulrestartintitiatesoranLSAchangeoccurs
duringgracefulrestart.WithstrictLSAcheckingdisabled,gracefulrestartdoes notterminatefor
theseconditions.
The“no”formofthis
commandenablesstrictLSAchecking.
interval Specifiesthemaximumamountoftimeinsecondsthatthisrouterwill
remainingraceful‐restartmodestartingatthetimeitentersgraceful‐
restart.Validvaluesare1‐1800seconds.Defaultvalueis120seconds.