Understanding RADIUS Snooper show radius-snooping port
26-8 RADIUS Snooping Configuration
Example
ThisexampleshowshowtodisplayRADIUSconfigurationinformation:
Matrix(rw)->show radius-snooping
RADIUS Snooping: Enabled
Number of configured flows: 2
Active sessions: 12
Enabled ports: fe.1.1-fe.1.8; fe.1.22
show radius-snooping port
UsethiscommandtodisplaybothageneraloverviewoftheglobalRSstatusaswellastheper
portRSstatusfortheport(s)specified.
Syntax
show radius-snooping port port-string
Parameters
Defaults
None.
Mode
Read‐Only.
Example
ThisexampledisplaystheRSstatusforportfe.1.1:
Matrix(rw)->show radius-snooping port fe.1.1
Radius-Snooping: Enabled
Port Port State Timeout Drop State Allowed Allocated
fe.1.1 disabled 40 enabled 1024 1024
Table 26-1 Radius-Snooping Settings
Output... What it displays...
RADIUS Snooping Specifies whether RS is globally enabled or disabled.
Number of configured flows Specifies the number of globally configured flows for this system.
Active sessions Specifies the number of active sessions for this system.
Enabled ports Specifies the ports RS is currently enabled on.
port‐string Specifiestheportforstatustobedisplayed.