Enterasys Matrix DFE-Gold Series

Configuring Node Aliases clear nodealias config
14-8 Node Alias Configuration
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoclearallnodealias entriesonfe.1.3:
Matrix(rw)->clear nodealias port-string fe.1.3
clear nodealias config
Usethiscommandtoresetnodealiasstatetoenabledandclearthemaximumentriesvalue.
Syntax
clear nodealias config port-string
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthenodealiasconfigurationonfe.1.3:
Matrix(rw)->clear nodealias config fe.1.3
port‐stringport‐string Specifiestheport(s)onwhichtoremoveallnodealiasentries.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.
alias‐idalias‐id SpecifiestheIDofthenodealiastoremove.Thisvalue
canbeviewed
usingtheshownodealiascommandasdescribedin“shownodealias”
onpage 14‐1.
port‐string Specifiestheport(s)onwhichtoresetthenodealiasconfiguration.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐2.