Enterasys Matrix DFE-Gold Series

show port Reviewing Port Status
Enterasys Matrix DFE-Gold Series Configuration Guide 4-13
Reviewing Port Status
Purpose
Todisplayoperatingstatus,duplexmode,speed,porttype,andstatisticalinformationabout
trafficreceivedandtransmittedthroughoneorallswitchportsonthedevice.
Commands
Thecommandsusedtoreviewportstatusarelistedbelowanddescribedintheassociated
sectionsasshown.
show port
Usethiscommandtodisplaywhetherornotoneormoreportsareenabledforswitching.
Syntax
show port [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,operationalstatusinformationforallportswillbedisplayed.
Mode
Switchcommand,Read‐Only.
Examples
Thisexampleshowshowtodisplayoperationalstatusinformationfor1‐GigabitEthernetport14
inmodule3:
Matrix(rw)->show port ge.3.14
Port ge.3.14 enabled
For information about... Refer to page...
show port 4-13
show port status 4-14
show port counters 4-15
show port operstatuscause 4-17
clear port operstatuscause 4-18
port‐string (Optional)Displaysoperationalstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.