Enterasys Matrix DFE-Gold Series

set spantree stpmode Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-11
Example
ThisexampleshowshowtodisplaytheSTPmode:
Matrix(rw)->show spantree stpmode
Bridge Stp Mode is set to ieee8021
set spantree stpmode
UsethiscommandtogloballyenableordisabletheSpanningTreeProtocol(STP)mode.
Syntax
set spantree stpmode {none | ieee8021}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodisableSpanningTree:
Matrix(rw)->set spantree stpmode none
clear spantree stpmode
UsethiscommandtoresettheSpanningTreeprotocolmodetothedefaultsettingofIEEE802.1.
Thisre‐enablesSpanningTree.
Syntax
clear spantree stpmode
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
none DisablesSpanningTree.
ieee8021 Enables802.1Spa n ning Treemode.