Enterasys Matrix DFE-Gold Series

show igmp reporters Configuring IGMP
Enterasys Matrix DFE-Gold Series Configuration Guide 9-15
Example
Thisexampleshowshowtodisplayigmpinformationforvlan12:
Matrix(rw)->show igmp vlan 12
IGMP Vlan 12 Info
IGMP query state : Enabled
QueryInterval(sec.) : 125
Status : Active
IGMP Version : 2
Querier : 2.25.0.1
QueryMaxResponseTime(sec.) : 10
Robustness : 2
LastMemberQueryIntvl(sec.) : 10
QuerierUpTime : 4 D 23 H 8 M
Router(s) on ports : none.
Egressing ports : lag.0.1-2,4
show igmp reporters
UsethiscommandtodisplayIGMPreporterinformation.
Syntax
show igmp reporters [portlist portlist] [group group] [vlan-list vlan-list] [sip
sip]
Parameters
Defaults
Ifnoparametersarespecified,allIGMPreporterinformationisdisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaytheallIGMPreporterinformation:
Matrix(rw)->show igmp reporters
IGMP Reporters
Port Group Address Vlan Source IP ExpireTime(Sec) Flags
---------------------------------------------------------------
lag.0.2 224.0.0.251 1 Any 252 DYNAMIC
portlistportlist (Optional)Portorrangeofports.
groupgroup (Optional)GroupIPaddress(nonemeansshowallgroups)
vlan‐listvlan‐list (Optional)VLANIDorrangeofIDs(1‐4094)
sipsip (Optional)SourceIPaddress(nonemeansshowallsips)