Enterasys Matrix DFE-Gold Series

Configuring SNMP Notification Parameters show snmp notifyprofile
5-38 SNMP Configuration
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtodeletetheSNMPnotifyfilter“pilot1”:
Matrix(rw)->clear snmp notifyfilter pilot1 subtree 1.3.6
show snmp notifyprofile
UsethiscommandtodisplaySNMPnotifyprofileinformation.Thisassociatestargetparameters
toanSNMPnotifyfiltertodeterminewhoshouldnotreceiveSNMPnotifications.
Syntax
show snmp notifyprofile [profile] [targetparam targetparam] [volatile |
nonvolatile | read-only]
Parameters
Defaults
Ifnoparametersarespecified,allnotifyprofileinformationwillbedisplayed.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaySNMPnotifyinformationfortheprofilenamed“area51”:
Matrix(rw)->show snmp notifyprofile area51
--- SNMP notifyProfile information ---
Notify Profile = area51
TargetParam = v3ExampleParams
Storage type = nonVolatile
Row status = active
profile (Optional)Displaysaspecificnotifyprofile.
targetparam
targetparam
(Optional)Displaysentriesforaspecifictargetparameter.
volatile|nonvolatile
|read‐only
(Optional)Displaysnotifyfilterentriesofaspecificstoragetype.