Enterasys Matrix DFE-Gold Series

Device Management Methods
1-2 Introduction
• ConfigurethedevicetooperateasaGenericAttributeRegistrationProtocol(GARP)deviceto
dynamicallycreateVLANsacrossaswitchednetwork.
• RedirectframesaccordingtoaportorVLANandtransmitthemonapreselecteddestination
port.
• ConfigureSpanningTrees.
•ClearNVRAM.
• ConfigureinterfacesforIProuting.
• ConfigureRIP,OSPF,DVMRP,IRDPand
VRRProutingprotocols.
• Configuresecuritymethods,including802.1X. RADIUS,TACACS,CEP,SSHv2,MAClocking,
andDoSattackprevention.
• Configureaccesslists(ACLs).
Device Management Methods
TheMatrixSeriesdevicecanbemanagedusingthefollowingmethods:
•LocallyusingaVTtypeterminalconnectedtotheconsoleport.
• RemotelyusingaVTtypetermina lconnectedthroughamodem.
• RemotelyusinganSNMPmanagementstation.
•In‐bandthroughaTelnetconnection.
•In‐bandusingEnterasysNetworks’NetSight
®
managementapplication.
• RemotelyusingWebView™,EnterasysNetworks’embeddedwebserverapplication.
TheEnterasysMatrixSeriesInstallationGuideprovidessetupinstructionsforconnectingaterminal
ormodemtotheMatrixSeriesdevice.