Enterasys Matrix DFE-Gold Series

show access-lists Configuring Access Lists
Enterasys Matrix DFE-Gold Series Configuration Guide 24-15
Configuring Access Lists
Purpose
Toreviewandconfiguresecurityaccesscontrollists(ACLs),whichpermitordenyaccessto
routinginterfacesbasedonprotocolandsourceIPaddressrestrictions.
Commands
show access-lists
UsethiscommandtodisplayconfiguredIPaccesslistswhenoperatinginroutermode.
Syntax
show access-lists [number]
Parameters
Defaults
Ifnumberisnotspecified,theentiretableofaccesslistswillbedisplayed.
Mode
Routercommand,Anyroutermode.
Example
ThisexampleshowshowtodisplayIPaccesslistnumber101.Thisisanextendedaccesslist,
whichpermitsordeniesICMP,UDPandIPframesbasedonrestrictionsconfiguredwiththeone
oftheaccess‐listcommands.Fordetailsonconfiguringstandardaccesslists,referto“ipaccess‐
group”
onpage 24‐20.Fordetailsonconfiguringextendedaccesslists,referto“access‐list
(extended)”onpage 24‐17.
Matrix>Router#show access-lists 101
Extended IP access list 101
permit icmp host 18.2.32.130 any
permit udp host 198.92.32.130 host 171.68.225.126 eq
Router: These commands can be executed when the device is in router mode only. For details on
how to enable router configuration modes, refer to “Enabling Router Configuration Modes” on
page 2-103.
For information about... Refer to page...
show access-lists 24-15
access-list (standard) 24-16
access-list (extended) 24-17
ip access-group 24-20
access‐list‐
number
(Optional)Displaysaccesslistinformationforaspecificaccesslist
number.Validvaluesarebetween1and199.