Enterasys Matrix DFE-Gold Series

Configuring Network Address Translation (NAT) set router limits (NAT)
18-14 Network Address Translation (NAT) Configuration
set router limits (NAT)
UsethiscommandtosetNATconfigurationlimits.
Syntax
set router limits {nat-bindings nat-bindings | nat-cache nat-cache |
nat-dynamic-configs nat-dynamic-configs | nat-static-config nat-static-config |
nat-interface-config nat-interface-config | nat-global-addr-cfg
nat-global-addr-cfg | nat-global-port-cfg nat-global-port-cfg}
Parameters
Defaults
None.
Mode
SwitchCommand:Matrix(rw)‐>.
Usage
Bindingsandcacheusevaluablememoryresources.Bydefaultthesesettingaresettomaximum
values.Usethiscommandtofreememoryresourcesbylimitingthenumberofbindingsandcache
size.
Thechassisorsystemmustberebootedforanynewchangetotakeeffect.
Thiscommandmustbeexecuted
fromtheswitchCLI.
nat‐bindings
nat‐bindings
(Optional)SpecifiesthemaximumnumberofNATbindingsforthis
router.Valuesrangefrom500to32000.Defaultvalueof32000.
nat‐cache
nat‐cache
(Optional)SpecifiesthemaximumNATcachesizeforthisrouter.Values
rangefrom100to2000.Defaultvalueof2000.
nat‐dynami c ‐configs
nat‐dynamic‐configs
(Optional)Specifiesthemaximumnumberofdynamicm apping
configurations.Valuesrangefrom1to10.Defaultvalueof10.
nat‐static‐config
nat‐static‐config
(Optional)SpecifiesthemaximumnumberofNATstaticmapping
configurationsforthisrouter.Valuesrangefrom1‐50.Defaultvalueof
50.
nat‐interface‐config
nat‐interface‐config
(Optional)SpecifiesthemaximumnumberofNATinterface
configurations.Valuesrangefrom4‐103.Defaultvalueof103.
nat‐global‐addr‐cfg
nat‐global‐addr‐cfg
(Optional)SpecifiesthemaximumnumberofNATglobaladdress
configurationsforthisrouter.Valuesrangefrom1‐1000.Defaultvalue

of1000.
nat‐global‐port‐cfg
nat‐global‐port‐cfg
(Optional)SpecifiesthemaximumnumberofNATglobalport
configurationsforthisrouter.Valuesrangefrom1‐32000.Defaultvalue
of32000.
Note: Router limits can also be set in the following contexts:
To set LSNAT router limits see set router limits (LSNAT) on page 19-33.
To set TWCB router limits see set router limits (TWCB) on page 23-15.