EasyManua.ls Logo

Enterasys Matrix DFE-Gold Series

Enterasys Matrix DFE-Gold Series
944 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Startup and General Configuration Summary
Enterasys Matrix DFE-Gold Series Configuration Guide 2-7
Using WebView
BydefaultWebView(EnterasysNetworks’embeddedwebserverfordeviceconfigurationand
managementtasks)isenabledonTCPportnumber80oftheMatrixSeriesdevice.Youcanverify
WebViewstatus,enableordisableWebView,asdescribedinthefollowingsection.
Displaying WebView status:
TodisplayWebViewstatus,entershowwebviewattheCLIcommandprompt.
ThisexampleshowsthatWebViewisenabledonTCPport80,thedefaultportnumber.
Matrix(rw)->show webview
WebView is Enabled. Configured listen port is 80.
Enabling / disabling WebView:
ToenableordisableWebView,entersetwebview{enableodisable}attheCLIcommandprompt.
ThisexampleshowshowtoenableWebView.
Matrix(rw)->set webview enable
Starting and Navigating the Command Line Interface
Using a Console Port Connection
OnceyouhaveconnectedaterminaltothelocalconsoleportasdescribedinyourMatrixSeries
InstallationGuide,thestartupscreen,Figure 2‐1,willdisplay.YoucannowstarttheCommandLine
Interface(CLI)by
•Usingadefaultuseraccount,asdescribedin“LogginginwithaDefault
UserAccount”on
page 2‐7,or
•Usinganadministratively‐assigneduseraccountasdescribedin“Logginginwith
AdministrativelyConfiguredAccount”onpage 2‐8.
Logging in with a Default User Account
IfthisisthefirsttimeyourareloggingintotheMatrixSeriesdevice,orifthedefaultuseraccounts
havenotbeenadministrativelychanged,proceedasfollows:
1. Attheloginprompt,enteroneofthefollowingdefaultusernames:
– roforRead‐Onlyaccess,
– rwforRead‐Writeaccess.
– adminforSuperUseraccess.
2. PressENTER.ThePasswordpromptdisplays.
Note: Depending on which Matrix Series device you are using, your default command prompt may
be different than the examples shown.
Note: By default, the Matrix Series device is configured with three user login accounts: ro for Read-
Only access; rw for Read-Write access; and admin for super-user access to all modifiable
parameters. The default password is set to a blank string. For information on changing these default
settings, refer to “Setting User Accounts and Passwords” on page 2-15.

Table of Contents

Related product manuals