Enterasys Matrix DFE-Gold Series

set rmon history Configuring RMON
Enterasys Matrix DFE-Gold Series Configuration Guide 11-19
Sample 2304 Interval Start: 0 days 19 hours 11 minutes 35 seconds
Drop Events = 0 Undersize Pkts = 0
Octets = 0 Oversize Pkts = 0
Packets = 0 Fragments = 0
Broadcast Pkts = 0 Jabbers = 0
Multicast Pkts = 0 Collisions = 0
CRC Align Errors = 0 Utilization(%) = 0
set rmon history
UsethiscommandtoconfigureanRMONhistoryentry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
Defaults
•Ifbucketsisnotspecified,themaximumnumberofentriesmaintainedwillbe50.
•Ifnotspecified,intervalwillbesetto30seconds.
•Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowconfigureRMONhistoryentry1onportfe.2.1tosampleevery30
seconds:
Matrix(rw)->set rmon history 1 fe.2.1 interval 20
clear rmon history
UsethiscommandtodeleteoneormoreRMONhistoryentriesorresetoneormoreentriesto
defaultvalues.Forspecificvalues,referto“setrmonhistory”onpage 11‐19.
Syntax
clear rmon history {index-list | to-defaults}
index Specifiesanindexnumberforthisentry.
port‐string (Optional)Assignsthisentrytoaspecificport.
bucketsbuckets (Optional)Specifiesthemaximumnumberofentriestomaintain.
intervalinterval (Optional)Specifiesthesamplingintervalinseconds.
ownerowner (Optional)Specifiesanownerforthisentry.