Enterasys Matrix DFE-Gold Series

set rmon event properties Configuring RMON
Enterasys Matrix DFE-Gold Series Configuration Guide 11-25
set rmon event properties
UsethiscommandtoconfigureanRMONevententry,ortocreateanewevententrywithan
unusedeventindexnumber.
Syntax
set rmon event properties index [description description] [type {none | log | trap
| both}] [community community] [owner owner]
Parameters
Defaults
•Ifdescriptionisnotspecified,nonewillbeapplied.
•Ifnotspecified,typenonewillbeapplied.
•Ifownerisnotspecified,monitorwillbeapplied.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtocreateandenableanRMONevententrycalled“STPtopology
change”thatwillsendbothalogentryandanSNMPtrapmessagetothe“public”community:
Matrix(rw)->set rmon event properties 2 description “STP topology change" type
both community public owner Manager
set rmon event status
UsethiscommandtoenableanRMONevententry.Anevententrydescribestheparametersofan
RMONeventthatcanbetriggered.EventscanbefiredbyRMONalarmsandcanbeconfiguredto
createalogentry,generateatrap,orboth.
Syntax
set rmon event status index enable
index Specifiesanindexnumberforthisentry.Maximumnumberofentriesis
100.Maximumvalueis65535.
descriptiondescription (Optional)Specifiesatextstringdescriptionofthisevent.
typenone|log|trap
|both
(Optional)SpecifiesthetypeofRMONeventnotificationas:none,alog
tableentry,anSNMP
trap,orbothalogentryandatrapmessage.
community
community
(Optional)SpecifiesanSNMPcommunitynametouseifthemessage
typeissettotrap.FordetailsonsettingSNMPtrapsandcommunity
names,referto“ConfiguringSNMPTargetAddresses”onpage 5‐29.
ownerowner (Optional)Specifiesthe
nameoftheentitythatconfiguredthisentry.