Enterasys Matrix DFE-Gold Series

show ip pim neighbor Configuring PIM
Enterasys Matrix DFE-Gold Series Configuration Guide 17-7
Parameters
Defaults
Ifnotspecified,informationaboutallPIMinterfaceswillbedisplayed.
Mode
Routercommand,PrivilegedEXEC:Matrix>Router#
Example
ThisexampleshowshowtodisplayPIMinterfaceinformation
Matrix>Router#show ip pim interface
Address Vlan Ver/Mode Nbr-Count Query-Intvl DR-Prior DR
------------------------------------------------------------------------------
35.0.0.1 35 v2/S 1 30 1 35.0.0.2
23.0.0.1 23 v2/S 0 30 1 23.0.0.1
20.0.0.2 20 v2/S 0 30 1 20.0.0.2
10.0.0.1 10 v2/S 2 30 87 10.0.0.1
Table 17‐2providesanexplanationofthecommandoutput.
show ip pim neighbor
UsethiscommandtodisplayinformationaboutdiscoveredPIMneighbors.
Syntax
show ip pim neighbor [interface]
interface (Optional)DisplaysinformationaboutaspecificPIMinterface.This
interfacemustbeenabledwithPIMasdescribedin“ippimsparse
mode”onpage 17 ‐2.
Table 17-2 show ip pim interface Output Details
Output... What it displays...
Address IP address of the PIM interface.
Vlan VLAN ID of the PIM interface.
Ver/Mode Version and mode (sparse or dense) of PIM running on the interface.
Nbr-Count Total number of PIM neighbors on the interface, discovered by
receiving PIM hello messages from other PIM routers on the interface.
Query-Intvl Interval between Hello messages. Default is 30 seconds.
DR-Prior Designated router priority value on the interface. Set with the ip pim
dr-priority command (“ip pim dr-priority” on page 17-3).
DR IP address of the designated router on the LAN.