Enterasys Matrix DFE-Gold Series

Enterasys Discovery Protocol set cdp interval
3-6 Discovery Protocols Configuration
Adevicewiththedefaultauthenticationcode(16nullcharacters)willrecognizealldevices,no
matterwhattheirauthenticationcode,andenterthemintoitsCDPneighbortable.
Example
ThisexampleshowshowtosettheCDPauthenticationcodeto1,2,3,4,5,6,7,8:
Matrix(rw)->set cdp auth 1,2,3,4,5,6,7,8
set cdp interval
Usethiscommandtosetthemessageintervalfrequency(inseconds)oftheCDPdiscovery
protocol.
Syntax
set cdp interval frequency
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosettheCDPintervalfrequencyto15seconds:
Matrix(rw)->set cdp interval 15
set cdp hold-time
UsethiscommandtosettheholdtimevalueforCDPdiscoveryprotocolconfigurationmessages.
Syntax
set cdp hold-time hold-time
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
frequency SpecifiesthetransmitfrequencyofCDPmessagesinseconds.Valid
valuesarefrom5to900seconds.
hold‐time SpecifiestheholdtimevalueforCDPmessagesinseconds.Validvalues
arefrom15to600.