Enterasys Matrix DFE-Gold Series

show port operstatuscause Reviewing Port Status
Enterasys Matrix DFE-Gold Series Configuration Guide 4-17
show port operstatuscause
Usethiscommandtodisplaythecausesconfiguredtoplaceoperatingstatustoadownor
dormantstateforoneormoreports.
Syntax
show port operstatuscause [port-string] [any] [modifiable][admin] [linkloss]
[linkflap] [self] [init] [flowlimit] [policy] [cos] [dot1x] [lag]
Parameters
Defaults
Ifnooptionsarespecified,causesforallportswillbedisplayed.
MIB2 Interface Counters MIB2 network traffic counts
802.1Q Switch Counters Counts of frames received, transmitted, and filtered.
Table 4-2 show port counters Output Details
Output... What it displays...
port‐string (Optional)Displayscausesforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntax
UsedintheCLI”onpage 4 ‐2.
any (Optional)Displaysatableofallcauses.
modifiable (Optional)Displaysatableofmodifiablecauses.
admin (Optional)DisplaysportsdownduetoadminStatus.
linkloss
(Optional)Displaysportsdownduetolinkloss.
linkflap (Optional)Displaysportsdownduetolinkflapviolation.Formore
informationonconfiguringthelinkflapfunction,referto“Configuring
LinkTrapsandLinkFlapDetection”onpage 4‐39.
self (Optional)Displaysportsdownduetoahardwarecause.
init (Optional)Displaysports
ininitializationphase.
flowlimit (Optional)Displaysportsdownduetoaflowlimitingconstraint.For
moreinformationonconfiguringflowlimiting,whichisalsoknownas
flowsetupthrottling, referto“ConfiguringFlowSetupThrottling
(FST)”onpage 24‐25.
policy (Optional)Displaysportsdownduetopolicyrestriction.Formore
information
onconfiguringuserpolicies,refertoChapter 8.
cos (Optional)DisplaysportsdownduetoClassofServiceconstraint.For 
moreinformationonconfiguringClassofService,referto“Configuring
PolicyClass ofService(CoS)”onpage 8‐21.
dot1x (Optional)Displaysportsdormantdueto802.1Xenforcement.For
moreinformationonconfiguring
802.1X,referto“Configuring802.1X
Authentication”onpage 25‐2.
lag (Optional)DisplaysportsdormantduetoLinkAggregationGroup
(LAG)membership.FormoreinformationonconfiguringLAG,referto
“ConfiguringLinkTrapsandLinkFlapDetection”onpage 4‐39.