Enterasys Matrix DFE-Gold Series

Configuring Spanning Tree Bridge Parameters clear spantree priority
6-22 Spanning Tree Configuration
clear spantree priority
UsethiscommandtoresettheSpanningTreeprioritytothedefaultvalueof32768.
Syntax
clear spantree priority [sid]
Parameters
Defaults
Ifsidisnotspecified,prioritywillberesetonSpanningTree0.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtoresetthebridgepriorityonSID1:
Matrix(rw)->clear spantree priority 1
show spantree bridgehellomode
Usethiscommandtodisplaythestatusofbridgehellomodeonthedevice.
Syntax
show spantree bridgehellomode
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Only.
Usage
Whenenabled,asinglebridgeadministrativehellotimeisbeingused.Whendisabled,per‐port
administrativehellotimesarebeingused.
sid (Optional)ResetsthepriorityonaspecificSpanningTree.Validvalues
are0‐4094.Ifnotspecified,SID0isassumed.