Enterasys Matrix DFE-Gold Series

set inlinepower threshold Configuring Power over Ethernet (PoE)
Enterasys Matrix DFE-Gold Series Configuration Guide 2-67
Example
Thisexampleshowshowtoclearpowerassignmentstoallmodulesinthechassis:
Matrix(rw)->clear inlinepower assigned
set inlinepower threshold
UsethiscommandtosetthePoEusagethresholdonaspecifiedmodule.
Syntax
set inlinepower threshold usage-threshold module-number
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
ThisexampleshowshowtosetthePoEthresholdto50onmodule1:
Matrix(rw)->set inlinepower threshold 50 1
clear inlinepower threshold
UsethiscommandtoresetthePoEusagethresholdonaspecifiedmoduletothedefaultvalueof
75percent.
Syntax
clear inlinepower threshold module-number
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
usage‐threshold SpecifiesaPoEthresholdasapercentageoftotalsystempowerusage.
Validvaluesare1‐99.
module‐number SpecifiesthemoduleonwhichtosetthePoEthreshold.
module‐number SpecifiesthemoduleonwhichtoresetthePoEthreshold.