Enterasys Matrix DFE-Gold Series

clear spantree spanguardtrap enable Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-41
clear spantree spanguardtrap enable
UsethiscommandtoresettheSpanningTreespanguardtrapfunctionbacktothedefaultstateof
enabled.
Syntax
clear spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthespanguardtrapfunctiontoenabled:
Matrix(rw)->clear spantree spanguardtrapenable
show spantree backuproot
UsethiscommandtodisplaythestateoftheSpanningTreebackuprootfunction.
Syntax
show spantree backuproot [sid]
Parameters
Defaults
Ifsidisnotspecified,statuswillbeshownforSpanningTree0.
Mode
Switchcommand,Read‐Only.
Example
ThisexampleshowshowtodisplaythestatusofthebackuprootfunctiononSID0:
Matrix(rw)->show spantree backuproot
Backup Root is set to disable on sid 0
sid (Optional)DisplaysstatusforaspecificSpanningTree.Validvaluesare
0‐4094.Ifnotspecified,SID0isassumed.