Enterasys Matrix DFE-Gold Series

set spantree newroottrapenable Configuring Spanning Tree Bridge Parameters
Enterasys Matrix DFE-Gold Series Configuration Guide 6-45
set spantree newroottrapenable
UsethiscommandtoenableordisabletheSpanningTreenewroottrapfunction.
Syntax
set spantree newroottrapenable {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,Read‐Write.
Usage
WhenSNMPtrapmessagingisconfigured,thissendsatrapmessagewhenaSpanningTree
becomesthenewrootofthenetwork.
Example
Thisexampleshowshowtoenablethenewroottrapfunction:
Matrix(rw)->set spantree newroottrapenable enable
clear spantree newroottrapenable
UsethiscommandtoresettheSpanningTreenewroottrapfunctionbacktothedefaultstateof
enabled.
Syntax
clear spantree newroottrapenable
Parameters
None.
Defaults
None.
Mode
Switchcommand,Read‐Write.
Example
Thisexampleshowshowtoresetthenewroottrapfunctiontoenabled:
Matrix(rw)->clear spantree newroottrapenable
enable|disable Enablesordisablesthebackuproottrapfunction.