Enterasys Matrix DFE-Gold Series

show ip nat statistics Configuring Network Address Translation (NAT)
Enterasys Matrix DFE-Gold Series Configuration Guide 18-11
Examples
ThisexampledisplaystheNATstatisticsforthisrouter:
Matrix->Router(config)#show ip nat statistics
Nat current status: Active
Nat secure plus: Disable
Total translations: 953 (0 static, 953 dynamic)
Outside interface: vlan 3000, vlan 21, vlan 20
Inside interface: vlan 3005, vlan 3004, vlan 3003, vlan 3002, vlan 3001,
vlan 15
Created translations:961, Expired translations: 8, Misses:0
Binding Resource Allocation Failures: 0
Thisexampledisplaysaportionoftheverboseversionoftheaboveexample:
Matrix->Router(config)#show ip nat statistics verbose
Nat current status: Active
Nat secure plus: Disable
Nat maximum allowed translation entries: 32000
All nat timeout value display in minutes:
timeout udp-timeout tcp-timeout icmp-timeout ftp-timeout dns-timeout
----------------------------------------------------------------------------
4 4 4 1 4 4
Total translations: 2660 (0 static, 2660 dynamic)
Outside interface: vlan 3000, vlan 21, vlan 20
Inside interface: vlan 3005, vlan 3004, vlan 3003, vlan 3002, vlan 3001,
vlan 15
Created translations:2755, Expired translations: 95, Misses:0
Binding Resource Allocation Failures: 0
Dynamic mappings:
-- Inside Source
access-list 31 refcount 1008
pool vlan 3000: netmask 0.0.0.0
start 81.1.1.1 end 81.1.1.1
type napt, total addresses 1, allocated 1, max_ports 32000, used_ports 1019 (3
%),
misses 0
.
.
.