Enterasys Matrix DFE-Gold Series

Configuring 802.1X Authentication show dot1x
25-4 Authentication Configuration
Mode
Switchcommand,Read‐Only.
Examples
Thisexampleshowshowtodisplay802.1Xstatus:
Matrix(rw)->show dot1x
DOT1X is disabled.
Thisexampleshowshowtodisplayauthentication diagnosticsinformationforfe.1.1:
Matrix(rw)->show dot1x auth-diag fe.1.1
Port: 1 Auth-Diag:
Enter Connecting: 0
EAP Logoffs While Connecting: 0
Enter Authenticating: 0
Success While Authenticating: 0
Timeouts While Authenticating: 0
Fail While Authenticating: 0
ReAuths While Authenticating: 0
EAP Starts While Authenticating: 0
EAP Logoff While Authenticating: 0
ReAuths While Authenticated: 0
EAP Starts While Authenticated: 0
EAP Logoff While Authenticated: 0
Backend Responses: 0
Backend Access Challenges: 0
Backend Other Requests To Supp: 0
Backend NonNak Responses From Supp: 0
Backend Auth Successes: 0
Backend Auth Fails: 0
Thisexampleshowshowtodisplayauthentication sessionstatisticsforfe.1.1:
Matrix(rw)->show dot1x auth-session-stats fe.1.1
Port: 1 Auth-Session-Stats:
Session Octets Rx: 0
Session Octets Tx: 0
Session Frames Rx: 0
Session Frames Tx: 0
Session Id: (1, 00-00-00-00-00-00)
Session Authentic Method: Remote Auth Server
Session Time: 0 secs
Session Terminate Cause: Port Failure
Session UserName:
Thisexampleshowshowtodisplayauthentication statisticsforfe.1.1: