Enterasys Matrix DFE-Gold Series - Page 147

router Reviewing and Configuring Routing
Enterasys Matrix DFE-Gold Series Configuration Guide 2-105
DHCP Host
Configuration Mode
Configure DHCP host
parameters.
Type client-identifier
and the identifier, or
hardware-address and
an address from any
DHCP configuration
mode.
Matrix>router
(config-dhcp-host)#
Note: To jump to a lower configuration mode, type exit at the command prompt. To revert back to
switch CLI, type exit from Privileged EXEC router mode.
Table 2-9 Router CLI Configuration Modes (continued)
Use this mode... To... Access method... Resulting Prompt...