Enterasys Matrix DFE-Gold Series - Page 537

traceroute Managing Switch Network Addresses and Routes
Enterasys Matrix DFE-Gold Series Configuration Guide 12-7
Defaults
•Ifnotspecified,waittimewillbesetto5seconds.
•Ifnotspecified,first‐ttlwillbesetto1second.
•Ifnotspecified,max‐ttlwillbesetto30seconds.
•Ifnotspecified,portwillbesetto33434.
•Ifnotspecified,nquerieswillbesetto3.
•If‐
risnotspecified,normalhostroutingtableswillbeused.
•If‐disnotspecified,thedebugsocketoptionwillnotbeused.
•Ifnotspecified,toswillbesetto0.
•If‐Fisnotspecified,the‘don’tfragment’bitwillnotbeapplied.
•Ifgatewayisnotspecified,
nonewillbeapplied.
•If‐Iisnotspecified,UDPdatagramswillbeused.
•If‐visnotspecified,summaryoutputwillbedisplayed.
•If‐xisnotspecified,checksumswillbecalculated.
Mode
Switchcommand,Read‐Only.
Usage
ThreeUDPorICMPprobeswillbetransmittedforeachhopbetweenthesourceandthe
traceroutedestination.
‐d (Optional)Setsthedebugsocketoption.
‐ttos (Optional)Setsthetypeofservice(TOS)tobeusedinprobepackets.
‐F (Optional)Setsthe‘don’tfragment’bit.
‐ggateway (Optional)Specifiesaloose
sourcegateway(upto8can bespecified),or
specifiesaspecificgateway,suchasgw1.
‐I (Optional)SpecifiestheuseofICMPechorequestsratherthanUDP
datagrams.
‐n (Optional)Displayshopaddressesnumerically.(Supportedinafuture
release.)
‐v (Optional)Displaysverboseoutput,includingthesizeanddestination
of
eachresponse.
‐x (Optional)Preventstraceroutefromcalculatingchecksums.
host SpecifiesthehosttowhichtherouteofanIPpacketwillbetraced.
packetlen (Optional)Specifiesthelengthoftheprobepacket.