MPC5606S Microcontroller Reference Manual, Rev. 7
Functional ports
Freescale Semiconductor 106
PK[8] PCR[129] Option 0
Option 1
Option 2
Option 3
GPIO[129]
MDO2
PDI[16]
—
— SIUL
Nexus
PDI
—
I/O M1 None,
None
— 42 D11
PK[9] PCR[130] Option 0
Option 1
Option 2
Option 3
GPIO[130]
MDO3
PDI[17]
—
— SIUL
Nexus
PDI
—
I/O M1 None,
None
— 44 A10
PK[10] PCR[131] Option 0
Option 1
Option 2
Option 3
GPIO[131]
SDA_1
eMIOSA[15]
—
— SIUL
I
2
C_1
PWM/Timer
—
I/O S None,
None
— 52 N6
PK[11] PCR[132] Option 0
Option 1
Option 2
Option 3
GPIO[132]
SCL_1
eMIOSA[14]
—
— SIUL
I
2
C_1
PWM/Timer
—
I/O S None,
None
— 53 N5
PK[12] — — Reserved — — — — — — — —
PK[13] — — Reserved — — — — — — — —
PK[14] — — Reserved — — — — — — — —
PK[15] — — Reserved — — — — — — — —
1
Alternate functions are chosen by setting the values of the PCR[n].PA bitfields inside the SIUL module. PCR[n].PA=00 Option 0; PCR[n].PA=01 Option 1;
PCR[n].PA=10 Option 2; PCR[n].PA=11 Option 3. This is intended to select the output functions; to use one of the input functions, the PCR[n].IBE bit must be
written to 1, regardless of the values selected in the PCR[n].PA bitfields. For this reason, the value corresponding to an input-only function is reported as —.
2
Special functions are enabled independently from the standard digital pin functions. Enabling standard I/O functions in the PCR registers may interfere with
their functionality. ADC functions are enabled using the PCR[APC] bit; other functions are enabled by enabling the respective module.
3
Using the PSMI registers in the System Integration Unit Lite (SIUL), different pads can be multiplexed to the same peripheral input. Please see the SIUL chapter
of the MPC5606S Microcontroller Reference Manual for details.
4
See Table 3-5.
5
Reset configuration is given as I/O direction and pull, for example, “Input, Pullup”.
6
This option on this pin has alternate functions that depend on whether the QuadSPI is in SPI mode or in serial flash mode (SFM).
7
Out of reset, pins PH[0:3] are available as JTAG pins (TCK, TDI, TDO, and TMS, respectively). It is up to the user to configure pins PH[0:3] when needed.
8
This pin can be used for LCD supply pin VLCD. Refer to the voltage supply pin descriptions in the MPC5606S data sheet for details.
Table 3-4. Port pin summary (continued)
Port
pin
PCR
register
Alternate
function
1
Function
Special
function
2
Peripheral
3
I/O
direction
Pad
type
4
RESET
config.
5
Pin number
144 LQFP 176 LQFP
208 MAPBG
A
To Next Page
Loading...
