Display Control Unit (DCU)
MPC5606S Microcontroller Reference Manual, Rev. 7
364 Freescale Semiconductor
Figure 12-13. Control Descriptor Cursor 4 Register (CtrlDescCursor_4)
12.3.4.12 DCU Mode Register (DCU_MODE)
Figure 12-14 represents the DCU_MODE register.This register sets the mode in which DCU is operating.
Offset: 0x1CC Access: User read/write
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
R 0 0 0 0 0 0 0 0
HWC_BLINK_OFF
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
R 0 0 0 0 0 0 0
EN_BLINK
HWC_BLINK_ON
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Table 12-15. CtrlDescCursor_4 field descriptions
Field Description
8–15
HWC_BLINK_OFF
HWC blink register. Loads the counter value (number of frames) for which the cursor will remain
turned OFF.
23
EN_BLINK
Enable the cursor blink mode.
0 Disable the blink mode
1 Enable the blink mode
24–31
HWC_BLINK_ON
HWC blink register. Loads the counter value (number of frames) for which the cursor will remain
turned ON.
To Next Page
Loading...
